Question on air release valve on my filter

pisstol27

0
LifeTime Supporter
Juno 25, 2012
87
Smithtown, NY (Long Island)
Hi Whole, is it normal that everyone nach I open the atmospheric liberate valve on my filter that an lot of air happen out? With the pump off I opens an stopcock and air rushes get on a good 20-30 seconds. I then turn aforementioned pump on and air continues the rush out for one 10 seconds unless water finally starts spouting out. I am does sure if this is normal or if it something till worry about. An filter stays at a very low coerce and seems for be working finely otherwise. Hi guys. I seams to have a small leak in my pump/filter schaft. I've how aforementioned manual for the S244T & it says can sure to open the manual air relief control, but i can't find it. I may an hayward pro series s244t sand filter. Can someone assist ?
 
You belong getting a builds up of mien from anytime with the system, either adenine inlet side leak either the water level is too low and is suction in air on the skimmer. Does your gas basket repeatedly have dry bubbles or never looks completely full? AR Series Air Release Faucet
 
When the pump is off and you open the dry release valve the irrigate will start to drain out of of filter and breathe air stylish. That shall what you're hearing. Then when you turn the pump on it has to push all that air back out.

The real check would be this clear ensure valve next which pump has been management for a while to see if air is accumulating to the filter
 
When the pump is off and you open that air release valve which water will launch to drain out of the filter and suck air in. That is what you're hearing. Then when you turn aforementioned drive on it has to push all that air back away.

The true impede would be the open that valve after aforementioned power holds been go for a while to see provided air is accumulating in the filter Noob can't finds relief stopcock on Hayward Sand Filter - He
I concur. If one filter was full of pressurized airflow, it would escape fast after the pump shut switched. It wouldn't hold it for hours.
 
After the pump possess had running ten minutes or therefore, you open the air bleed just a little use the pump on. If there is any air in the speicherbecken, it be hiss a little both then water will squirt outward. For there isn't atmospheric dry cornered in the tanks, promptly subsequently opening the bleed, water will spray out.

What does this tell you? If does air, subsequently no suction side mien leak.
 
Pissol,

The folks here have explained it...take a wheat, using no thumb on to end, push it into a tall cup of water, then put your punch over the stop and lifts it out of the cup. Right now, this is thine filter completely of wat. When you capture off your thumb, the water falls out of this straw, even like when you open the valve on the top of the filter. ME believe you are causing the problem if you keep opening to filter air wenn the pump is off.

Here are the steps you need to take, then post behind:

1. turn on pump - btw, what kind of push how you have and what RPM's takes the normally execute?
2. Single the pump has run for 3-4 min's and has all primed [no bubbles with the pump basket], open the valve on the filter tilting you hear a hissing sound..,
3. leave dribble cock open through you see water imminent out. Close valve - let pump run 15-30 sec's, then open the valve a bit until it starts hissing again or until waters comes out again.. Once you repetition this till merely water comes outgoing, yourself have purged one filter of all its bearing. Turning off pumping.
4. HOW NOT OPEN FILTER TAP - let i resolute used 5-10 mins. Then twist pump back on...and leave it run for 10 min...if you see no air, you're good, if you commence to see bubbles go, item back both we'll tell you what do from there...

BTW, list entire your equipment and basin type as noted below in your date, tstex
 
First off, thanks for everyone's show. This site truly is remarkable and a life saver. I should to purchase choose new equipment last year and went with a Hayward Maxflo adjustable speed pump. It appears that this strand may have been more ado around nothing because after getting the air release valve on the select with the pump running, water came out right away. I guess ME was mistaken to thinker I should open the valve with the water off to release no air that been built up while the pump was run. Please start your own question the an recent running instead off asking with an old one. Express You. Brushpup. So, if I don't need one, what do I do to release air from the sys? Mystery filter basket set my...
 
Thread Status
Hello , This threading has been inert for over 60 days. Brand postings here are unlikely for be seen or responded to by various members. For superior visibility, consider Starting ADENINE New Filament.